Reasons and solutions for blockage of pipelines in fully automatic diesel powered sprayers. The pipe clogging phenomenon caused by excessive pressure during spraying is too long when the spraying is carried out, the pressure is too high when the height is too high, and the other is the special foreign matter blocking by spraying, and the pressure inside the mortar pipe is raised, so that the interface is secreted. The phenomenon of water causes the blockage of the pipeline. This phenomenon of pipeline blockage is generally pre-existing. During the spraying process, the flow rate is obviously reduced, and the operating pressure is gradually increased. At this time, the operator should stop the equipment and pipeline in time. In the early stage of clogging, it is generally at the discharge port, and the cleaning at the take-over is relatively simple. If the equipment is not blocked in time, the pipe can only be cleaned by washing the pipe with water, and the right hose is selected to be flushed from the lower right.
