Multi-functional cement mortar sprayer is suitable for reinforcement, leveling, painting and pumping.
1.When the pump pressure is insufficient during operation, the booster stator bolt can be adjusted, or the booster rubber sleeve and the booster screw can be replaced.
2.Before spraying, the painted wall should be smeared with water to avoid affecting the adhesion to the mortar.
3.When loading into the hopper, it must be uniform and not interrupted. When the conveying screw rotates, it is strictly forbidden to stir in the hopper with a stick to prevent injury and find an accident.
4.Once the mortar conveying pipe is blocked, the switch can be switched to the manual position. Only the air compressor is opened, the joint in front of the pump head is removed, and then the spraying is blocked downward, so that the wind pressure generates a reverse pressure, thereby the inside of the conveying pipe. The remaining pulp is blown out. After installing the connector, you can start working normally.
5.The pressurized hose and the booster screw are wearing parts. In order to prolong the service life, the booster stator bolt should be in a loose state when it is used for the first time; when the pressure is reduced and the flow rate is significantly reduced, the compression bolt is adjusted to make it in normal working condition.
